亚洲国产精品久久不卡毛片_yyyy11111少妇无码影院_国产九九九九九_国产精品免费av_精品国一区二区三区_乱码专区一卡二卡国色天香

歡迎來到東莞市艾維品實業有限公司官網!

東莞市艾維品實業有限公司

專業研發、生產、銷售各種花紋的水轉印膜

全國咨詢熱線

400-0253-888

新聞資訊

新聞中心

當前位置: 首頁 > 新聞中心 > 化州公司新聞

化州水轉印加工技術操作方法

2023-06-02 09:02:52

1. 確定適當水溫 (20 °C – 30°C),水面保持溢流狀態。

Make sure the proper water temperature (20 °C - 30 °C), keep water at overflow state.


2. 保持水表面無活化劑殘留及雜質。

Keep the water surface without activator residues and impurities.


3. 置膜,以適當角度將膜平放于水面(確定膜之正反面,印刷層朝上)

Put the film on the water flatly with the proper angle.( Confirm the film positive & negative, printing side up)


4.配合水溫設定溶解時間,水溫一般為25-30度,溶解時間約為45秒到2分鐘

Set dissolution time with water temperature which is often 25°C-30 °C. The dissolution time is about 45 seconds to 2 minutes.


5.視印刷油墨之厚度,判定噴涂活化劑之時間,油墨層越厚,可在膜尚未完全溶解時,提前噴涂活化劑,讓油墨活化時間加長,而一般作業情況溶解1分鐘左右可噴涂活化劑,待膜成鏡面而平坦擴展(5秒-15秒)即可上膜、轉印。

Spray activator time depends on the thick of printing ink. The thicker the ink layer, spray activator in advance before the film not yet completely dissolved, to make the ink activate time much longer. General operation condition is about 1 minute to dissolve, then spray activator. After flat extension of the film (5 seconds -15 seconds), then put the film to be printed and transferred .


6. 在上膜之前需視加工物之外形或有紋路性,選擇下水角度,以利于空氣排出。

Select water down angle to exhaust air well as the dip items' shape or lines prior to film transfer . 


7. 上膜后,不可立即拿起,應在水中搖晃3-5秒,切斷邊緣之膜,增加紋路咬住被加工物之時間。

Do not take out the work piece immediately after transfer the film. Shake it on the water for 3-5 seconds, to cut the edge's film and increase the lines to bite work piece's time.


8. 活化劑噴涂需以0.8mm*4孔噴槍及可攪拌式壓力操作業,噴涂距離約30cm,空氣壓力適當調整避免花紋脫落,不可有水花產生,必要時水溫可加到35°C, 水槽之水量需作溢, 最后一道水需干凈,沖洗完成需經空氣吹干并經品管修整再入烘烤爐。

Spray activator with 0.8mm * 4 hole spray gun and operate by stirred pressure. Spray distance is about 30cm. Adjust air pressure properly to avoid the film pattern fall off, and water can't be splashed. Add water temperature to 35 °C if necessary. The tank water is overflow and the last water must be clean. After rinse, then dry by oven. 


不同的圖案,必須使用不同的底色,如木紋基本使用棕色、咖啡色、土黃色等,石紋基本使用白色等.

 Different film pattern , different base coat. e.g. Wood grain (often Brown, khaki), Marble grain (often white etc).


近期瀏覽:

contact us

東莞市艾維品實業有限公司

廣東省東莞市樟木頭鎮金河社區濱河路31號

水轉印膜丨水轉印耗材丨水轉印設備

水轉印產品代加工丨水轉印技術支持

水轉印開發、生產、加工、銷售、培訓一條龍服務

contact us

         


         掃一掃 添加微信

SERVICE

聯系人:(董先生)

133-7860-9888

全國熱線

400-0253-888

座機

0769-81723888

0769-87123588

24小時在線客服
主站蜘蛛池模板: 久久99久久99精品免视看婷婷 | 国产精品186在线观看在线播放 | 国产精品996 | 髙清视频播放在线观看 | 国产欧美日韩精品久久久 | 日韩免费在线视频观看 | 精品久久久久久久一区二区伦理 | 在线观看免费毛片 | 亚洲 成人 一区 | 成人精品99 | 免费观看9x视频网站在线观看 | 3p国产| 成人在线免费公开观看视频 | 久久视频在线观看免费 | 91精品国产综合久久小仙女图片| 曰韩av| 91高跟黑色丝袜呻吟在线观看 | 精品视频免费在线观看 | 国产精品久久久久久久免费大片 | 日韩欧美一区二区在线观看 | 欧美精品一区二区免费 | 日韩在线一区二区视频 | 狠狠色狠狠色综合日日小说 | 久草在线资源总站 | 被男人添B超爽视频免费 | 91色精品视频在线 | 日韩在线小视频 | 精品二区在线 | 欧美精选视频一区二区 | 午夜精品免费视频 | 狠狠干狠狠艹 | 亚洲综合av在线播放 | 欧美精品免费观看二区 | 日韩精品 在线视频 | 国产热RE99久久6国产精品首页 | 国产女人乱人精品三区 | 成人网页 | 久久这里有 | 四虎国产精品一区 | 精品少妇一区二区三区在线视频 | 久草香蕉在线 |